TECHNICAL INFORMATIONS OF LOCKING SYSTEM

MECHANICAL LOCKING SYSTEMS

1 / Timing belt joint

Locks for T10 and AT10 pitches

The locks save maintenance time and afford your work teams complete freedom of action. The belts are supplied:

• pre-prepared (cut to length and machined to the teeth and back level)
• together with the kit (plates and screws).

The back of the belt is thicker owing to the inclusion of the locks.

Consult us for the specifications to be provided when ordering. A single quick connection kit can also be supplied.

For belts with weld-on profiles a minimum distance of 100 mm between the profiles is required.

2 / Pin joint connections

The “PIN JOINT” system is available for the pitches T10, AT10, H, T20 and AT20 (other pitches on request). The ends are cut into fingers as for a weld, and then the teeth are pierced to allow the insertion of metal rods, which provide the connection.

The belt is assembled at the assembly site thanks to a mounting tool.

The mounting tool is available on request.

Available widths: 25, 32, 50 and 75 mm.

3 / BRECO® metal cross-teeth

When high loads are applied to the profiles it is advisable to use metal cross-teeth to fasten the profiles. Precautions must be taken in terms of the wrap diameters to prevent the tension members from being ruptured by the bending stresses.

Metal teeth AT10

Metal teeth AT20