First, the new generation BRECOFLEXmove® belt available in the AT10 profile is specifically designed for high precision, high dynamic effort applications. It has a high stiffness to reduce the width of the transmission and improved slip thanks to the PTFE fabric on the tooth side. The belt can be made to the desired length.

Firstly, the Synchroflex® GEN III belt is suitable for high-precision high dynamic effort applications. In addition, the specific polyurethane gives it a higher resistance, a longer life and a temperature resistance up to 100 ° C. The belt is produced from a one-piece molded sleeve.

CONTI® Synchrochain Carbon belt is reserved for very high load transfers. The belt is produced from a one-piece molded sleeve.

CONTI® Synchronous Aramid Belt is reserved for high speeds and extreme dynamic loads. The belt is produced from a one-piece molded sleeve, available lengths according to molds.

The standard BRECOFLEX® belt is suitable for applications requiring precision synchronization. With a wide variety of steps / profiles that can adapt to all kinematics and constraints with a wide range of options. The belt can be made to the desired length and made with double teeth.

The self-guided BRECOFLEX® belt removes the flanges on the pulleys and eliminates the lateral drift of the belt. The arc-shaped BAT profile belt reduces noise and has optimized meshing. Finally it requires a perfect alignment of the pulleys and can be made to the desired length.

The standard Synchroflex® belt is suitable for applications requiring good synchronization. The belt is therefore produced from a molded sleeve integrally, available lengths following molds.

The high-profile, high-profile BRECOFLEX® belt is suitable for power applications requiring very good synchronization and no backlash. The belt can be made to the desired length.

The high-profile, high-profile Synchroflex® belt is suitable for power applications requiring very good synchronization and no backlash. The belt is therefore produced from a molded sleeve integrally.

The micromechanical Synchroflex® belt is designed for low load transmissions in a small footprint. Finally, the belt is produced from a molded sleeve integrally.

The CONTI® Synchroforce belt is suitable for basic power transfers with high loads. The belt is thus produced from a vulcanized sleeve in one piece.

The CONTI® Synchrotwin double toothed belt is particularly suitable for basic power transfers with high loads. The belt is thus produced from a vulcanized sleeve in one piece.